PERSONAL INJURY HAZARD - To reduce the risk of injury to persons, install fan so the blades are 7 ft.ELECTRIC SHOCK HAZARD - To reduce the risk of electric shock, make sure the electricity has bee turned off at the circuit breaker or fuse box before beginning installation.ELECTRIC SHOCK HAZARD - To reduce the risk of electric shock, this fan must be installed with an isolating wall control/switch.Consult a qualified licensed electrician if in doubt. Most outlet boxes commonly used for the support of lighting fixtures are not acceptable for fan support and may need to be replaced. FIRE, ELECTRIC SHOCK OR PERSONAL INJURY HAZARD - To reduce the risk of fire, electric shock, or personal injury, mount to an outlet box marked “ACCEPTABLE FOR FAN SUPPORT OF 35.1 lbs OR LESS” and use the mounting screws provided with the outlet box.It will permanently damage the fan’s remote control receiver and cause the fan’s functions to fail. ELECTRIC SHOCK HAZARD - Do not install this fan with variable speed wall control or wall-mounted dimmer switch. The net weight of this fan including the light kit is: 15.7 lbs.Electrical diagrams are for reference only.Disconnect the electrical supply circuit to the fan before installing kit.Splices after being made should be turned upward and pushed carefully up into the outlet box.All set screws must be checked and retightened during and before installation.After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one side of the outlet box and the ungrounded conductor on the other side of the outlet box.Electrical installation should be performed by a qualified licensed electrician. All wiring must be in accordance with the National Electrical Code “ANSI/NFPA 70” and local electrical codes.When using an existing outlet box, be sure the box is securely attached to the building structure and can support the full weight of the fan, so to avoid potential serious injury or death.Please read and understand this entire manual before attempting to assemble, operate or install the product. Helpful Tools (not included): Electrical circuit tester. Tools Required for Assembly (not included): Phillips screwdriver, step ladder, electrical tape, pliers, wire cutters, wire strippers. If any part is missing or damaged, do not attempt to assemble the product. Compare parts with package contents list and hardware contents list. Harbor Breeze 00728 Mazon 44-in Brushed Nickel Indoor Residential Flush mount Ceiling Fan with Light Kit Included and Remote Control Included (3-Blade) - Use Manual - Use Guide PDF.īefore beginning assembly of product, make sure all parts are present.
0 Comments
Leave a Reply. |